EAGLE6 M105 Tokyo Marui Next-Gen Upgrade Spring

Beschikbaarheid: Op voorraad
Levertijd: Standaard DPD verzending

- M105, This will give around 360 FPS.

- Made with high quality steel

- Heat Treated

- Measured every 10 springs

- Linear Spring For Increased Consistency

- Designed specifically for the Next Gen Recoil Shock AEG Range

- Ground Ends For Increased Consistency

Eagle6 Airsoft - M105 Spring For Next Generation Recoil Shock Series

Product Information

This spring is specifically designed for the Next generation aeg's from Tokyo Marui which use a shorter than normal aeg spring in there gearbox. Using a oversize'd aeg spring in one of these gearbox's will cause excess wear to your stock tube threads or poor cycling / reduced battery efficiency. These springs are Heat treated and use high quality steel and are made in England. These Springs are tested every 10 springs and measured for consistency during the manufacturing process. These are also deliberately made as a linear spring for a more consistent fps reading shot to shot.

This spring will fit all Next Generation Recoil Shock AEG's but may produce slightly higher power results on SCAR Next Gen series.

To give a rough example this spring on a stock next generation m4 socom will give consistently 350 - 360 FPS tested over 5 springs.

**Tech note - FPS results vary between guns and depending on upgrades, hop rubbers and air seals. We do a full range of springs with consistent power increases so you can change up or down if you arnt getting the results you desire**

0 sterren op basis van 0 beoordelingen
Wij slaan cookies op om onze website te verbeteren. Is dat akkoord? Ja Nee Meer over cookies »